FL3X Interface-S

With the FL3X Interface family a highly variable automotive bus interface solution for Dataloggers and PCs, which supports the current and upcoming bus and network systems via pluggable physical layer modules and the usage of a FPGA.

The FL3X Interface-S has hard-wired FlexRay, CAN-HS/FD, LIN/SENT and 100BASE-T1 channels and also one FL3X Tiny3 Slot for pluggable transceiver. Because of its free mountable Tinyslot and the usage of a FPGA, it can be extended with any available or upcoming FL3X Tiny3 and communication channel.

• 1Gbit/s Ethernet and WiFi interface

• FL3X Tiny3 exchangeable Physical Layer slots

• 3x SUB-D connector

• 8-42 V

• LEDs signal the state of the network

• One pluggable transceiver modules (2-6 channels per module depending on the bus system)

• Pluggable transceiver modules available for CAN-HS, CAN-FD, CAN-FD SIC, FlexRay, LIN, SENT*, K-Line*, RS232*, SPI

• Pluggable transceiver modules 100BASE-T1, 1000BASE-T1only for Tap mode

• Compact form factor

• Synchronous timestamp generation for most of the bus interfaces (resolution up to 1 µs)

• Configurable bus termination

• Bosch E-Ray IP core FlexRay controller

• Bosch D_CAN IP core CAN controller

• Bosch M_CAN IP core CAN-FD Controller

• Intel Triple-Speed-Ethernet Ethernet controller

• V2.1 A FlexRay protocol specification

• V2.0 A/B CAN protocol specification

• ISO 11898-1:2015 CAN protocol specification

• Bosch CAN-FD specification 1.0

  * API possible but not available at the moment

CAN-HS / CAN-FD*

• Silent mode useable for listening without bus interference

• Configurable TX-acknowledges

*no ACK Flag, no Bus Errors

FLEXRAY*

• Asynchronous monitoring mode allows listening without FlexRay-Synchronicity

• Chronological correlation of bus messages with one timestamp base

*no state messages available, no bus states, no error messages, no bus symbols, no CC State